Daikin BRC1C71 Engineering Data page 61

Control Devices
If controlling one indoor unit or one group of
indoor units with two remote controllers
Change the MAIN/SUB changeover switch setting as
described below.
S S
1
M
S
2
M
1 Main remote controller (factory set)
2 Sub remote controller
Set one remote controller to
MAIN and the other to SUB.
NOTE 1. If controlling with one remote controller, be sure to
set it to MAIN.
2. Set the remote controller before turning the power
supply on.
" is displayed for about one minute when the power supply is
turned on. During this time the remote controller can not be
operated.
5. Permission level function
If required, you can limit the user action by restrict FIELD
SETTINGS.
Level
1 All
2 • on/off button
• schedule timer button
• temperature adjust button
• operation change/
• fan speed button
• air flow direction adjust button
3 • on/off button
• temperature adjust button
• fan speed button
For switching between level 1 permission and the selected
level in service, proceed as follows:
1 Keep the FAN SPEED button pressed,
2 and press the 3 other indicated buttons simultaneously
while keeping the FAN SPEED button pressed.
2
2
If you want to limit the user action on the remote controller
to be defined as SUB, start with only connecting this
controller to the unit. Make sure that this controller is set to
MAIN (factory set) first, change the permission level to the
setting you prefer and only then set the remote controller
to SUB.
You can now proceed with connecting the remote
controller to be defined as MAIN.
60
PCB
Operable buttons
button
1+2
2
6. Field settings
If optional accessories are mounted on the indoor unit, the
indoor unit setting may have to be changed. Refer to the
instruction manual for each optional accessory.
a
UNIT No.
b
GROUP
c
4
3
1
7
6
a Unit No.
b First Code No.
c Second Code No.
d Mode No.
e Field set mode
Procedure
1. When in the normal mode, press the
minimum of four seconds, and the FIELD SET MODE is
entered.
2. Select the desired MODE NO. with the "TEMP" button.
3. During group control, when setting by each indoor unit
(mode No. 20, 21, 22 and 23 have been selected), push
the FUNCTION button and select the INDOOR UNIT NO.
to be set. (This operation is unnecessary when setting by
group.)
4. Push the upper button and select FIRST CODE NO.
5. Push the lower button and select the SECOND CODE
NO.
6. Push the "SCHEDULE" button once and the present
settings are SET.
7. Push the button to return to the NORMAL MODE.
Example
If during group setting and the time to clean the air filter is set to
FILTER CONTAMINATION - HEAVY, SET MODE NO. to [10],
FIRST CODE NO. to [0], and SECOND CODE NO. to [02].
NOTE 1. Setting is carried out in the group mode, however, if
the mode number inside the parentheses is
selected, indoor units can also be set individually.
2. The SECOND CODE No. is set to "01" when
shipped from the factory.
3. Do not make any settings not given in the table.
4. Not displayed if the indoor unit is not equipped with
that function.
5. When returning to the normal mode,
displayed in the LCD in order for the remote
controller to initialize itself.
6. It is not possible to change field settings on the
remote controller that is set to
EDUS39-605
d
SETTING
e
5 2
button for a
may be
SUB.
Controls