Daikin BRC1C71 Engineering Data page 47

Control Devices
5. Control Mode Selector (DS2)
The following four patterns of control mode can be set:
Control Mode Individual
Content Operation/stop is
controlled by both unified
ON/OFF controller and
remote controller.
DS2 Setting
(Factory set)
Note:
Indicates the position of switches.
Set control mode before turning power supply ON.
When used in conjunction with central remote controller, the control modes of the central remote controller takes
priority.
6. Forced Reset Switch (SS1)
When changing the setting of the connectorwhen setting the master controller, you can reset simply by switching it
to the reset side and back again without turning the power OFF.
For normal operation, set the switch to the normal, or off position, side.
46
Centralized Timer Operation Possible by
Remote Controller
After operation by unified When used in conjunction
ON/OFF controller, with the schedule timer,
operation/stop is freely operation/stop is controlled
controlled by remote freely by remote controller
controller until stopped by during the set time but
unified ON/OFF controller. operation is not available
when the schedule timer is
ON.
EDUS39-605
ON/OFF Control Impossible
by Remote Controller
Operation/stop is controlled
by unified ON/OFF controller
only. This unit can not be
operated/stopped by remote
controller.
Controls