Daikin BRC1C71 Engineering Data page 24

EDUS39-605
Use the following procedure to set operation mode:
Continue to push Operation switch
for about 4 seconds.
sign blinks on all the indoor units
connected to the outdoor unit or BS
unit.
1
Description of operation and its function:
Remote control having the
selection eligibility
( Remote controller having
no
Remote control having the
selection eligibility
( Remote controller having
no
Note: Selection modes are also available on the wireless remote controller. It is not possible to set DRY mode with the
Central Remote Controller.
Controls
Operation ON/OFF
Set to Cooling, Heating
and Auto (only for Heat
Recovery series);
)
sign.
Set to [Fan];
)
sign.
2. Selection Eligibility
2
Setting
3. Operation mode
3
changeover
Other remote controller
( Remote controller having
no sign.
Other remote controller
( Remote controller having
no sign.
Control Devices
Push Operation switch of the remote
controller, which you want to set the
selection eligibility. This completes the
setting procedure. Cool/heat selection
eligibility is set for that remote controller,
and sign goes off.
still blinks on all other remote
controllers.
Push Operation switch of remote
controller having the selection
eligibility (The remote controller not
displaying sign) several times
to select the desired operation mode.
[Fan], [Dry], [Auto](only for Heat Recovery
series),[Cooling] and[Heating] mode are
selected each time you push the
[Operation switch]. Operation mode of
other remote controllers, which has no
selection eligibility, is also switched
automatically.
• Changes to the operation mode
selected by the remote controller
having the selection eligibility.
)
• However, you can still change to
[Fan], or change from [cooling] to
[dry].
• Can only be set to [Fan].
)
(V1397)
(V1398)
23