Daikin BRC1C71 Engineering Data page 60

EDUS39-605
2.7.5 Installation
The kit includes the following parts:
Remote controller
Wall plugs
1. Remove the upper part of remote controller
1
Insert a minus screwdriver into the slots (1) in the lower part
of the remote controller (2 places), and remove the upper
part of the remote controller.
The PC board is mounted in the upper part of the
remote controller. Be careful not to damage the
board with the minus screwdriver.
2. Fasten the remote controller
1
for exposed mounting, fasten with the two included wood
1
screws (Ø4x30) and plugs.
for flush-mounting, fasten with the two included machine
2
screws (M4x16).
For the field supplied switch box, use optional accessory
KJB111A or KJB211A.
Choose the flattest place possible for the
NOTE
mounting surface. Be careful not to distort the
shape of the lower part of the remote controller
by overtightening the mounting screws.
Controls
Wood screws
Machine screws
2
3. Wire the indoor unit
P2 P1
1
4
1 indoor unit
2 lower part of the remote controller
3 upper part of the remote controller
4 wired from the rear
5 wired from the top
6 notch the part for the wiring to pass through with nippers
Connect the terminals on top of the upper part of the remote
controller (P1, P2), and the terminals of the indoor unit (P1,
P2). (P1 and P2 do not have polarity.)
NOTE When wiring, run the wiring away from the power
supply wiring in order to avoid receiving electric
noise (external noise).
Wiring specifications
Wiring type
2 conductor, stranded, non-
shielded copper cable / PVC or
vinyl jacket
NOTE Peel the shield for the part that has to pass through the
inside of the remote controller case (
4. Reattach the upper part of the remote
controller
Be careful not to pinch the wiring when
attaching.
First begin fitting from the clips at the bottom.
NOTE 1. The switch box and wiring for connection are
not included.
2. Do not directly touch the PC board with your
hand.
Control Devices
6
P2 P1
1
2
3
5
Size
AWG18
).
1
59