Socket RS-232 serial User Manual page 19

CSA connects either automatically or with manual initiation.
Depending on how your configured the CSA, it may automatically connect
with the remote device, or you may need to manually initiate a connection.
In the previous scenarios, the following should happen:
SCENARIO 1: Set up a CSA pair for cable replacement.
After you attach the CSA to each device (with each powered on), they
should automatically try to connect.
Example: After you attach the initiator CSA to the laptop and the acceptor
CSA to the printer, the two CSA's will automatically try to connect.
SCENARIO 2: Set up one CSA as passive serial Bluetooth receiver.
After you attach the CSA, your device will be discoverable and ready to
accept a Bluetooth connection. Perform a device discovery from the
initiator device, then commence the connection.
Example: The industrial equipment with the CSA will be discoverable and
ready to accept a Bluetooth connection. Perform a device discovery from
the Bluetooth enabled Pocket PC, then start the connection.
Important!
Make sure you manually configure your baud rate and other settings in any
third-party applications used with the CSA. Auto-detect and Plug and Play
functions are not reliable with Bluetooth, and the CSA may not work
properly unless you manually enter the correct settings.
CHAPTER 2: SETUP | 19