Table of Contents
Advertisement
,
Repairs to the gas and electrical
components of this appliance must
only be carried out by a suitably
qualified and competent person to
ensure safety (Gas Safe registered
in the UK). Repairs and other work
by unqualified persons could be
dangerous. The manufacturer
cannot be held liable for
unauthorised work.
What to do if ...
... the burner does not ignite when
the hob is being used for the first
time or after a long period of not
being used.
There could be an air lock in the gas
pipe. You may need to make several
attempts before the burner ignites
successfully.
... the in-operation and residual heat
indicators are flashing at the same
time.
– There has been a power cut.
– Re-ignition was not possible.
– The gas supply has been
interrupted.
Turn all the controls clockwise to the "ß"
position. You can then operate the
appliance as normal.
If the problem persists, disconnect the
appliance from the electricity supply for
a few seconds.
Problem solving guide
... there has been a power cut.
Turn all the controls clockwise to the "ß"
position. You can then operate the
appliance as normal.
If the problem persists, disconnect the
appliance from the electricity supply for
a few seconds.
... the burner does not ignite after
several attempts.
Disconnect the appliance from the
electricity supply for a few seconds. If
the problem persists, check whether
– the burner is assembled correctly.
– the gas supply tap is turned on.
– the burner is dry and clean.
– the flame slits are dry and
unblocked.
... the gas flame goes out after being
lit.
The flames need to touch the ignition
safety device so that it heats up
sufficiently.
If the flames do not touch the ignition
safety device, check that
– the burner components are
assembled correctly.
– there is no soiling on the ignition
safety device. If there is, remove it
carefully (see "Cleaning and care").
31
Advertisement
Table of Contents
