Intermec CV30 User Manual page 63

CV30 Fixed Mount Computer With Windows CE User's Manual
3 For Association, choose Open, WPA, WPA2, or Network
EAP.
4 For Encryption, choose TKIP or AES if you selected WPA2
for association, or WEP or CKIP if you selected Network
EAP for association.
5 For Username, type a unique username for this protocol.
6 Select Prompt for password to have the user enter this
password each time to access the protocol, or select Use
following password to use the protocol without entering a
password each time you use the CV30.
7 In the Password field, type a unique password for this
protocol.
8 Tap Get Certificates to obtain or import server certificates.
For help with certificates, see
page 62.
9 Tap Additional Settings to assign an inner PEAP
authentication and set options for server certificate validation
and trust.
10 From the Inner PEAP Authentication list, choose EAP/MS-
CHAP-V2, EAT/Token Card, or EAP/MD5-Challenge.
11 Check Validate Server Certificate to verify the identity of the
authentication server based on its certificate when using
PEAP.
12 Tap Root CA, select a root certificate, and then tap OK.
13 Enter the Common Names of trusted servers.
14 Tap OK.
Configuring TLS Security With Profile Wizard
EAP-TLS is a protocol based on the Transport Layer Security
(TLS) protocol widely used to secure web sites. This protocol
requires both the user and authentication server to have
certificates for mutual authentication.
To configure TLS security
1 In the Profile Wizard, select the Security page.
2 For 8021x Security, choose TLS.
Chapter 3 — Configuring the CV30
"Loading a Certificate" on
53