JVC GV-DS2 Instructions Manual page 71

MESSAGE
Enter correct value.
Your selection is not valid.
Set a value from 0 to 59.
Picture Wipe/Dissolve
functions and Black & White
Fader can not activate while
Sepia or Monotone is used.
This effect can not activate on
the in point of scene No. 01.
Invalid frame number on drop
frame counter.
PROBLEM
Dubbing does not go as
programmed, or the
programmed playback
displays an image similar to a
Fader effect (black fader,
mosaic fader, etc.).
Dubbing is impossible using a
VCR as a player.
POSSIBLE CAUSE
CORRECTIVE ACTION
You entered an incorrect device ID number.
Enter an ID number between 0 and 99 which is not
being used by another device (
The value of the CUT OUT point is smaller than the
CUT IN point's.
Set the value of the CUT OUT point so that it is
larger than the CUT IN point's (
You entered a value over 60.
Enter a value from 0 to 59 (
It is impossible to execute certain combination of
P.AE/Effects and Picture Wipes/Dissolve.
Cancel one of them or try another combination
( pg. 58).
You tried to use a Picture Wipe/Dissolve (button
with a "P") at scene "01".
Use a Picture Wipe (button without a "P") at scene
"01" ( pg. 59).
Because the DV-format digital camcorder uses the
drop frame system, inputting frame 00 and 01 is
impossible.
Input frame value other than 00 or 01 (
POSSIBLE CAUSE
CORRECTIVE ACTION
If the CUT IN point is programmed at the beginning
of a tape and programmed playback is to be
continued, the video device stops and programmed
playback is aborted.
Program the CUT IN point so that the tape is
forwarded/played back for approx. 20 to 30 sec.
from the beginning of the first recorded scene on the
tape ( pg. 52).
The counter may not be recognized due to dirt or
abnormalities on the tape.
When there are audio/video disturbances during
playback or when the scene's counter acts
abnormally, delete the scene from the programmed
playback or correct its CUT IN point (
When you click the "START" button using a JVC VCR
equipped with JLIP connector and High-Speed Search
function as a player, dubbing may be impossible.
Open the menu bar and click "Set-up" — "Pre-roll"
— "Long", then click the "START" button again.
71
EN
pg. 66).
pg. 56).
pg. 56, 57).
pg. 50).
pg. 56).