Camcorder Attachment - JVC GV-DS2 Instructions Manual

CAMCORDER ATTACHMENT

1
2
3
Lock !
Charging a battery Installed in the Camcorder . . .
Charger
indicator
Core
filter
Mark
LOCK lever
RELEASE button
If you attach the camcorder with a battery installed to the
Video Capture Docking Station, you can charge the battery.
First make sure that the camcorder does not have a DC cord
connected to it before attaching. Turn the camcorder's
Power Dial to "OFF" then perform the following steps.
1. Connect the Video Capture Docking Station to the AC
Power Adapter/Charger.
•The Video Capture Docking Station does not use the
camcorder's battery to function. Be sure to connect the
AC Power Adapter/Charger exclusively for use with the
camcorder.
2. Connect the power cord to an AC outlet.
•The Docking Station's charger indicator begins
(CHARGE) blinking to indicate that the charge has
begun. When it stops blinking and lights steadily, the
charge is complete. It takes approx. 2 hours to charge
the battery fully.
Before attachment, make sure the camcorder's
power is off.
1 .
OPEN COVER
Slide the Multi connector cover (MULTI) on
the bottom of the camcorder in the direction
of the arrow until you hear a click.
2 .
ATTACH
Attach the camcorder by aligning the mark on
it with the one on the Video Capture Docking
Station.
3 .
FIX
Slide the camcorder in the direction of the
arrow.
4 .
LOCK
While holding the camcorder, slide the LOCK
lever in the direction of the arrow.
To remove the camcorder . . .
... press the RELEASE button. After the LOCK
lever has been released, detach the
camcorder.
NOTE : If it is impossible to slide the lock
lever, repeat steps 2 and 3.
13
EN