Advanced Operations; Changing Id Number; Connecting Other Device During Operation - JVC GV-DS2 Instructions Manual

66
EN

Changing ID number

The device's ID number is preset at factory as follows:
ex. Camcorder: 06 or 07
When connecting more than two same type devices, the same ID numbers will exist and a
malfunction can occur. To avoid a malfunction, change the ID numbers.
It is recommended to change the ID number of an already connected device before connect-
ing the same type device.
ACCESS "ID CHANGE" DIALOG
1
BOX
Choose "ID Change" from "Set-up" on
the JLIP VIDEO PRODUCER window.
•The "ID Change" dialog box appears.
SELECT DEVICE
2
Click on the name of the device and
"CHANGE".
•The dialog box to enter new ID number
appears.
ENTER NEW ID NUMBER
3
ID Change
Select the device to change.
VCR
06:VCRCAMERA
VIDEO PRINTER

Connecting other device during operation

When connecting an other device during operation or changing ID numbers, initializing is
necessary to confirm the connected devices. (Not necessary to run "JLIP Video Producer
software" from beginning again.)
INITIALIZE
1
Choose "Initialize" from "Set-up" on the JLIP VIDEO PRODUCER window.
Video printer: 20
CHANGE CLOSE
CHANGE

ADVANCED OPERATIONS

SET ID NUMBER
4
Click "OK".
•The message "The device ID will be
changed." appears.
Clicking "OK" again sets that ID
number and brings up the JLIP VIDEO
PRODUCER window.
NOTES:
After step 4, perform the following
"Connecting other device during
operation".
Do not enter ID number "0" because "JLIP
Video Producer software" does not
recognize "ID 0".
ID Change
Enter a number between 1 and 99.
=
ID 06
OK CANCEL