Starting Jlip Video Producer Software - JVC GV-DS2 Instructions Manual

48

STARTING JLIP VIDEO PRODUCER SOFTWARE

EN
JLIP VIDEO
PRODUCER
Serial Port Selection
Select a Serial Port.
OK
Initializing JLIP
Now checking devices' ID ...
NOTE:
If a connection is incorrect, an error message
may be displayed and the connected device
name will not appear on-screen.
• The COM port used for the JLIP connector
is not selected, or the COM port is selected
but the connection is wrong. Check the
connected COM port and select it on the
"Serial Port Selection" screen.
• The BIOS settings on your PC are not
correct. Change the BIOS settings.
Refer to the PC's instruction manual or
consult the computer manufacturer for
details.
COM 1
COM 2
COM 3
COM 4
CANCEL
ID:10
Starting JLIP Video Producer Software
1
PREPARE DEVICE(S)
Turn the device(s) on and set the
camcorder's Power Dial to "PLAY".
2
ACCESS VIDEO PRODUCER
Double-click the JLIP VIDEO
PRODUCER icon and the Serial Port
Selection dialog box appears.
3
SELECT SERIAL PORT
Select the port number of the connector
you are using to connect the computer to
the Video Capture Docking Station.
•If the connector number is A, B... A
corresponds to 1.
•Click "OK".
•If the connection is correct, the Device
Selection dialog box appears.
•An error message "No devices detected
to connect. Power ON all devices in
system." appears . . .
... when a wrong port number is
selected.
... when the connection is wrong.
... when the device's ID number is
already in use.
... when the device's power is not
turned on.
Check the Serial Port selection, too.
To return to step 1, check the connection
and the device's power and try again.
•When all serial COM ports are
occupied by other applications the
error message "Error — This application
will close. Check devices — Confirm
that power is ON." appears. Free a
serial COM port to start up JLIP Video
Producer Software.