Resetting The Scanner - Radio Shack PRO-94 Owner's Manual

Problem
Channel activity
bars are flashing
but no sound is
heard.

RESETTING THE SCANNER

If the scanner's display locks up or stops operating
properly, you might need to reset the scanner.
Caution: This procedure clears all the information you
have stored in the scanner. Before you reset the scan-
ner, try turning it off and on to see if it begins working
properly. Reset the scanner only when you are sure it is
not working properly.
1. Turn off the scanner.
2. While holding down the
scanner.
the scanner clears its memory.
Note: Do not turn off the scanner again until
stops flashing. Otherwise, the scanner might not clear
its memory properly.
72
Possible Cause
The transmis-
sion might be a
private or tele-
phone intercon-
nect call. The
scanner does not
scan these types
of transmissions.
The ID shown is
not active.
CLEAR
flashes for about 5 seconds as
Remedy
Scan for another
transmission.
Wait for the ID to
become active, or
scan another
transmission.
and keys, turn on the
2 9
CLEAR