Forwarding Filtering; Unicast Forwarding; Static Multicast Forwarding - D-Link DES-3550 Manual

State <Disabled>
Click Apply to implement changes made.

Forwarding Filtering

Unicast Forwarding

Open the Forwarding Filtering folder in the Configuration menu and click on the Unicast Forwarding link. This will
open the Setup Static Unicast Forwarding Table, as shown below:
Figure 6- 29. Setup Static Unicast Forwarding Table and Static Unicast Forwarding Table
To add or edit an entry, define the following parameters and then click Add/Modify:
Parameter
VLAN ID (VID)
MAC Address
Allowed to Go Port
Click Apply to implement the changes made. To delete an entry in the Static Unicast Forwarding Table, click the
corresponding under the Delete heading.

Static Multicast Forwarding

The following figure and table describe how to set up Multicast Forwarding on the Switch. Open the Forwarding
Filtering folder and click on the Multicast Forwarding link to see the entry screen below:
DES-3550 Fast Ethernet Layer 2 Switch
operate as if the p2p value were false. The default setting for this parameter is true.
This drop-down menu allows you to enable or disable STP for the selected group of
ports. The default is Enabled.
Description
The VLAN ID number of the VLAN on which the above Unicast MAC address
resides.
The MAC address to which packets will be statically forwarded. This must be a
unicast MAC address.
Allows the selection of the port number on which the MAC address entered above
resides.
54