Preparation Before Operation - Daikin CTXS09GVJU Service Manual

Instruction

Preparation Before Operation

To operate the remote controller
• To use the remote controller, aim the transmitter at the indoor
unit. If there is anything to block signals between the unit and the
remote controller, such as a curtain, the unit will not operate.
• Do not drop the remote controller. Do not get it wet.
• The maximum distance for communication is about 23 Ft.
To fix the remote controller holder on the wall
1. Choose a place from where the signals reach the unit.
2. Fix the holder to a wall or pillar with the screws
supplied with the holder.
3. Place the remote controller in the remote controller
holder.
ATTENTION
About remote controller
• Do not put the remote controller in the following places.
• In direct sunlight.
• In vicinity of a heater.
• Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with soft cloth.
• Signal communication may be disabled if an electronic-starter-type fluorescent lamp (such
as inverter-type lamps) is in the room. Consult your authorized dealer if that is the case.
• If the remote controller signals happen to operate another appliance, move that appliance to
somewhere else, or consult your authorized dealer.
76
SiUS12-814
Operation Manual