Maintenance
Cleaning
c.) Slide the drive belt out from one end. Be
sure to roll the belt as shown.
Figure 27
d.) Remove the 1/4" hex bolt and nut inside
the control box that fastens the conveyor
support to the control box.
Figure 28
e.) Remove both conveyor assemblies. This
may require two people.
5. Remove the air plates as follows:
a.) Loosen the wing screws holding the air
plate retainers in place. Remove the four
wing screws from the control box end of
the oven.
b.) Slide the air plates straight out from both
ends of the oven.
22
Figure 29
Figure 30