Conveyor Belt - Blodgett MT3870 Installation, Operation & Maintenance Manual

Installation
Oven Assembly

CONVEYOR BELT

The belt has loops on both ends. These loops
must ride backward on the conveyor support. Also
note that the belt has a top and bottom. Refer to
Figure 9.
Figure 9
NOTE: Unless specified otherwise, conveyor trav-
el is factory set for left to right operation
when facing the front of the oven. If a direc-
tion change is required, the polarity of the
drive motor must be reversed. To reverse
the motor polarity, interchange the black
and white motor leads at the D.C. control-
ler located in the control panel. In addition,
the conveyor belt must be installed from
the left side of the oven.
1. Thread wire belt starting from the right hand
side of the oven, lower level first. Unroll the belt
as shown in Figure 10, otherwise the belt will
be upside down. Leave about one foot hang-
ing out on the left side
NOTE: If belt travel is from left to right, thread
2. Take the remainder of the belt, loop it around
Belt Top
the right shaft. Push through on the upper lev-
el.
8
wire belt starting from left side of oven.
Figure 10
Figure 11