3. The two ends of the belt should be approxi-
mately 6-9 inches past the left shaft on the up-
per level of the belt support. Right shaft if right
to left travel is required.
4. Install inner master links. See Figure 12 and
Figure 13.
Upside-down
Figure 12
Figure 13
5. Install the outer master links. See Figure 14
and Figure 15
NOTE: The extra piece of wire belt can be used to
make additional master links in the event
original links are lost or damaged.
Proper
Position
9
Installation
Oven Assembly
Figure 14
Figure 15