Table of Contents
Advertisement
DVR SETTING
From the DVR setup screen, you can specify the DVR type and baud rate.
1. Press [2] on the number pad.
Hold down the [SETUP] button to enter the DVR SETUP mode.
2. Enter the 4-digit password.
Default Password : 4321
J
The default password can be exposed to a hacking thread so it is recommended to
change the password after installing the product.
Note that the security and other related issues caused by the unchanged password
shall be responsible for the user.
3. To change a channel address, select a channel by moving the joystick to
the right or left. Or you can enter the channel number and then press the
[ENT] button.
4. Change the <BAUDRATE> and <PARITY> settings of the select
channel.
M
To move between the options, move the joystick up or down.
To change the value of the settings, move the joystick to the right or left.
For the default settings values, please refer to the picture on the right.
Protocol : Samsung Techwin SAMSUNG-T
BAUDRATE : 9.6K, PARITY : NONE
5. Select the <SAVE> menu to save the changes.
You can continue changing the settings by selecting different channels.
To exit to the initial screen, select the <EXIT> menu or press the [ESC]
button.
J
After changing the settings of a channel, you must select the <SAVE> menu.
If you move to a different channel without using the <SAVE> menu, the changes
will not be saved.
Under Controller Serial Setup, Data Bit is fixed to 8 and Stop Bit to 1.
Serial values of the controller and camera must match each other.
[ D V R S E T U P 1 ]
PASSWORD [ **** ]
[ D V R S E T U P 1 ]
1. ADDRESS : 001
[ D V R S E T U P 1 N ]
2. BAUDRATE : 9.6K
[ D V R S E T U P 1 ]
3. PARITY : NONE
[ D V R S E T U P 1 ]
4. SAVE
[ D V R S E T U P 1 ]
5. EXIT
English _27
Hide quick links:
Advertisement
Table of Contents
