Setting Up Controller Environment; Ptz Setup; Controller Main Setup - Samsung SCC-1000 User Manual

Setting Up Controller Environment

1. PTZ Setup

Press 1 on the number pad.
①
Hold down the SET button to enter the PTZ SETUP
②
mode.
Enter the 4-digit password. (Default Password: 0000)
③
To change a channel address, select a channel by
④
moving the joystick to the right or left. Or you can
enter the channel number and then press the ENT
button.
Change the Protocol, Baud Rate, and Parity Bit settings
⑤
of the select channel.
Select the SAVE menu to save the changes. You can
⑥
continue changing the settings by selecting different
channels. To exit to the initial screen, select the EXIT
menu or press the ESC button.
• To move between the options, move the joystick up or
down.
• To change the value of the settings, move the joystick
to the right or left.
• For the default settings values, please refer to the
picture on the right.
Protocol : Samsung Techwin SPD
Baud Rate : 9.6Kbps, Parity Bit : None
Notes
• After changing the settings of a channel, you must select the Save menu. If you move to a different
channel without using the SAVE menu, the changes will not be saved.
• Under Controller Serial Setup, Data Bit is fixed to 8 and Stop Bit to 1. Serial values of the controller
and camera must match each other.
14
PTZ CONTROLLER User Guide
Setting Up Controller Environment

2. Controller Main Setup

Press 2 on the number pad.
①
Hold down the SET button to enter the controller's
②
MAIN SETUP mode.
Enter the 4-digit password. (Default Password: 0000)
③
After changing the settings, select <YES> in the
④
SAVE/EXIT menu to save the changes and move back
to the initial screen. To cancel changes and move
back to the initial screen, select <NO> in the Save
menu or press the ESC button.
• To move between the options, move the joystick up or down.
• To change the value of the settings, move the joystick to the right or left.
• For the default settings values, please refer to the picture on the right.
2-1. Firmware Version
■ Displays the current version of the controller firmware.
2-2. Serial Data Transfer Standard
■ Select RS-485 or RS-422.
2-3. LCD Backlight
■ AUTO : Turns the backlight off automatically if no
command has been entered in the last 30
seconds.
■ ON : Keeps the backlight on at all times.
■ OFF : Keeps the backlight off at all times.
PTZ CONTROLLER
15
User Guide