(2) Remove the two pan M3x6 screws.
(3) Remove the CDCC PCB from main frame L.
(4) Disconnect the CDCC PCB harness.
NOTE:
•
When replacing the main PCB, refer to
SETTINGS, REQUIRED AFTER PARTS REPLACEMENT' in Chapter
•
After disconnecting flat cable(s), check that each cable is not damaged at its end or
short-circuited.
When connecting flat cable(s), do not insert them at an angle. After insertion, check that
•
the cables are not at an angle.
Screws, Pan M3x6
CDCC PCB
(5) Remove the five cup S M3x6 taptite screws and FG harness ASSY 6.
(6) Remove the main PCB from main frame L.
Taptite, cup S M3x6
FG harness ASSY 6
Taptite, cup S M3x6
'ADJUSTMENTS AND UPDATING OF
CDCC PCB harness
5-47
Main PCB
Main frame L
Main PCB
Main frame L
6.
Confidential