[ 10 ] Inputting the adjusted value of the laser scanner
NOTE: Please refer to the illustration below for the identification and the location of the
laser unit serial label.
Laser unit serial label
NOTE: The error of "NG!!" may be shown after the input of the adjusted value but the entry
should be accepted correctly.
[ 11 ] Switch back to standby
Disconnect the USB cable and press the 9 key twice.
(1) Select 'Adjust Scanner' from Menu.
(2) Look for the laser unit serial label which
(3) Enter the last 4 digit numbers of the
(4) Then click the OK button.
Step (1)
Laser unit serial label
6 - 3
(See step1 of the left illustration)
can be found on the right of the main
PCB. (Refer to the NOTE below for the
laser unit serial label)
machine.
(See step3 of the left illustration)
Enter the last 4 digits shown on the label
Confidential