Side Opening Door Features - Westinghouse PON663 Owner's Manual

Front
• When locating the left side racks into the small
oven or grill ensure the pegs go into the top
access holes.
3. Shelves and trays
The shelves are designed so that they have maximum travel but cannot be accidentally pulled right
out. The trays are designed the same way and fit straight into the side racks.
• Locate the rear edge of the shelf/tray in between 2 guide rails of the side rack - see diagram.
Ensure the same rail positions on both sides of
the oven are being engaged.
• With the front edge raised, begin to slide the
shelf into the oven.
• Once the detents have passed the front edge of
the side rack, the shelf can be pushed
completely in.
• When fully inserted the shelf/tray should not
interfere with the closed oven door.
• To insert the grill tray in a separate grill
underbench product, fully open the drawer and
position the tray so that the slots on the outer
edges fit over the tabs on the slides.

Side opening door features

The door in side opening models has been designed
with some additional features for the best
performance of your oven. Firstly the door has three
layers of glass to keep the heat in the oven and maximise
energy whilst keeping the door outer as cool as possible.
To further minimise the external door temperature this
door has a unique "air curtain" between the two outer
most pieces of glass. The gaps at the top & the bottom of
the door allow cooling air to pass through the door
reducing the external temperature. The door has been
designed for the removal & cleaning of the door glass
should it become necessary, see the cleaning section of
this book for instructions.
The door is also reversible from right hand opening
[as delivered] to left hand opening. If you wish to
convert your door opening then refer to the installation
section of this book for instructions.
Rear 2. Side racks
The side racks that come with your oven are all
fitted the same way and can be attached to either
side of your oven.
• Insert the largest peg into rear access hole
provided. See diagram.
• Then locate the front peg into the front access
hole and push in firmly.
Rear
Front
7