Cleaning Oven Door [Side Opening Doors] - Westinghouse PON663 Owner's Manual

CLEANING YOUR APPLIANCE
Releasing the grill element
Retaining wire models
We have designed the upper element
with a hanger clip to help you reach
your oven roof for cleaning.
Retaining wire models
• Lift element up carefully.
• Pull hanger clip forward.
The element will drop down freely.
C l e a n i n g y o u r o v e n d o o r ( s i d e o p e n i n g d o o r )
Side opening door models have been
designed to allow the two inner door glasses
to be removed for cleaning.
• Open the door fully so the top screws on
each side can be accessed with a Philip's
head screwdriver.
• Remove the TOP two screws only found on
each side of the door, inside the corner cap
(see diagram)
• Lift the top trim upward to remove it.
Note: There is a seal fitted to the underside
of top trim, should it come off, ensure that
it is refitted before refitting the trim.
• The two inner pieces of glass can now be
individually removed from the door by
sliding them upwards.
• After cleaning, assemble the door in
reverse order.
IMPORTANT:
• NEVER spray any caustic oven cleaners on any surface of the door or damage to the surface
coatings will result.
• Do not use metal utensils, scrapers, scourers, or abrasive cleaners to clean the glass or any of
the door trims of the door. These will damage or scratch the surface coatings and degrade the
finish and appearance.
• Use only warm water & liquid detergent with a soft cloth to clean the glass or trims.
• Before refitting the glass to the door ensure they are dried also with a soft cloth.
• The glass edges have been specially ground to remove any sharp edges. However it is glass, and
should be handled carefully to avoid injury to your person or damage to the glass.
24
Rotating latch models
• Rotate latch 180º.
The element will drop down freely.
Top trim
Door inner
glass - Black
Note: The ceramic
paint is on the
inside of the door.
Door middle glass
This glass has a clear
heat reflective
coating on one side.
This side has been
marked with a
symbol 'O' to indicate
the reflective side.
This is printed on one
corner of the glass.
The reflective side
should face the oven
when the door is
closed.