Cleaning The Oven Door - Westinghouse WVG613S User Manual

CLEANING YOUR APPLIANCE (CONTINUED)
Removing and replacing the oven light
WARNING WARNING
Make sure the appliance is turned off before you remove
or replace parts, to avoid the possibility of electric shock.
• Turn oven light glass anticlockwise to remove it for
globe replacement.
• A special high temperature resistant globe should
be used. This can be purchased from the Customer
Care Centre.

Cleaning the oven door

WARNING CAUTION
Do not lift the door by the handle. Rough handling will
cause glass to break.
20
CLEANING
Removing the oven door
IMPORTANT TIPS & INFORMATION
Your oven is equipped with a door that can be
disassembled in order to clean all the panes of glass.
Remove the door before cleaning.
1. Open the door fully to access the hinges then rotate
the 'stirrups' on both hinges fully towards the oven.
2. Slowly close the oven door until it stops against the
'stirrups' (about 45°).
3. Grasp the oven door with a hand each side of the
door and remove it from the oven by pulling it
towards you.
4. Lay the oven door with the outer side facing
downwards on something soft and flat (for example a
blanket on a kitchen table) to prevent scratches.
Removing oven door top trim
• Take hold of the grid embossed sections of the door
trim at each end and press inwards to release the
clips. Remove the door trim by pulling it towards you.
Removing the door glass panels
WARNING
CAUTION
Rough handling, especially around the edges can cause
the glass to break.
1. Lift the black bordered glass panel out of the guide.
2. Repeat this for the smaller clear glass panel (when
fitted).
Cleaning the door glass panels
WARNING
CAUTION
Do not to use harsh abrasives on the glass panes as the
reflective surface plays a role in the function of the oven.
Do not place glass in dishwasher. Hand wash only with a
soft cloth and warm soapy water. When dry, polish with a
soft cloth and ensure the glass is dry before reassembly.
Removing the bottom trim (on selected models)
1. The bottom trim may be removed for cleaning by
snapping out and lifting away from the glass.
Re-assembling the bottom trim (on selected
models)
1. Push down to "snap" each side of bottom trim back
into door columns.
CLEANING
21