Lighting The Grill; Before Lighting - Amana SS 4 Use And Care Manual

Burner gas grill

Hide thumbs Also See for SS 4:

Use and care manual (31 pages)

Table Of Contents

Table of Contents

BEFORE LIGHTING

Important! Before Lighting...

Check the gas supply line for cuts, wear or abrasion.

Always keep your face and body as far away from the

grill as possible when lighting.

GRILL BURNER LIGHTING

Lighting the Grill with electronic igniter

1. Make sure all control knobs are in the "OFF" position.

2. Open the gas supply valve located on top of your L.P.

tank.

ATTENTION: When turning the L.P. tank on, make sure

to open the valve very SLOWLY two (2) complete turns

to insure proper gas flow.

3. Always open the hood before attempting to light.

4. Push and turn one of the control knobs counter clock-

wise to the "HIGH" position and immediately press the

electronic igniter button. You will hear a snapping

sound. It may be necessary to hold the electronic

starter button for about 4 seconds. (See Fig. 60)

NOTE: If the burner does not light in 4 seconds, turn

the knob to the "OFF" position and wait 5 minutes

before trying again.

5. Repeat above steps to light remaining burners.

Match Lighting

If by chance the electronic igniter does not light the burn-

er, the burner may be lit with a match. Keep your face as

far away from the grill surface as possible and place a lit,

long stem match through the spaces in the grill grates to

the ports of the back crossover burner between the flavor

grids. Position the match near the burner ports and push

and turn the control knob counter clockwise to the

"HIGH" position. (See Fig. 61-62)

Note: If the grill will not light after several attempts

see the trouble-shooting section of this manual. Turn

the control knobs to the OFF position when not in

use.