Lighting The Grill - Amana SS 5 Use And Care Manual

BEFORE LIGHTING
Important! Before Lighting:
• Check the gas supply line for cuts, wear
or abrasion.
• Always keep your face and body as far away
from the grill as possible when lighting.
GRILL BURNER LIGHTING
Lighting the Grill with electronic igniter
1. Make sure all control knobs are in the
"OFF" position.
2. Open the gas supply valve located on top of
your L.P. tank.
ATTENTION: When turning the L.P. tank on,
make sure to open the valve very SLOWLY
two (2) complete turns to insure proper
gas flow.
3. Always open the hood before attempting to
light.
4. Push and turn one of the control knobs count-
er clockwise to the "HIGH" position and
immediately press the electronic igniter
button. You will hear a snapping sound. It
may be necessary to hold the electronic
starter button for about 4 seconds.
(See Fig. 50)
NOTE: If the burner does not light in 4
seconds, turn the knob to the "OFF" position
and wait 5 minutes before trying again.
5. Repeat above steps to light remaining
burners.
MATCH LIGHTING
If by chance the electronic igniter does not light
the burner, the burner may be lit with a
match. Keep your face as far away from the
grill surface as possible and place a lit, long
stem match through the spaces in the grill
grates to the ports of the back crossover
burner between the flavor grids.

Lighting the Grill

Position the match near the burner ports
and push and turn the control knob counter
clockwise to the "HIGH" position.
(See Fig. 51-52)
Note: If the grill will not light after several
attempts see the trouble-shooting section of
this manual. Turn the control knobs to the
OFF position when not in use.
Do not attempt to "Light" the grill if
the odor of gas is present!!
Fig. 50
Fig. 51
Fig. 52
23
Crossover Burner