Amana SS 4 Use And Care Manual page 10

Burner gas grill
Hide thumbs Also See for SS 4:
Table of Contents

Advertisement

7. Using the four (4) long self tapping screws, install
the door catch magnets to the bottom of the front
grill flange. Start one screw and then the other
before tightening. Make sure to install the screws
at a slight angle as shown. (See Fig. 21)
8. Place left hand door on an angle over the left side
door pivot. (See Fig. 22)
9. Tilt the top of the door toward the grill, while
depressing the top door pivot pin above the door
edge. (See Fig. 23)
10. Move the door slightly until the pin locks into place
in the hole on top of the door. (See Fig. 24)
11. Repeat steps 8-10 for right door installation.
Assembly
8
Fig. 21
Install Screws At
An Angle
Fig. 22
Fig. 23
Fig. 24

Advertisement

Table of Contents
loading

Table of Contents