Sf100 Cabling - Multitech MultiModem iSMS SF100-G Administrator's Manual

SF100 Cabling

Plug one end of a RJ-45 cable into the LAN port on the MultiModem iSMS and the other end into your network or
1.
workstation interface.
Attach the cellular antenna.
2.
Connect the provided power supply cable to the 9 volt power port on the back of the MultiModem iSMS, and plug
3.
the other end into an AC power outlet.
About 30 seconds after you apply power, the unit's front panel Status and LAN LEDs report normally. For more
information about the LEDs, see Chapter 1.
Antenna Notes:
●
Be sure to locate this appliance where there is wireless coverage.
●
The antenna must be attached for the MultiModem iSMS to operate.
●
Maintain a separation distance of at least 20 cm (8 inches) between the transmitter's antennas and the body of the
user or nearby persons. The product is not designed for, nor intended to be, used in applications within 20 cm (8
inches) of the body of the user.
17
Chapter 2 – Getting Started
MultiModem® iSMS Administrator's Guide