Faxfinder 430/830 (Ff830 Shown); Installing And Cabling Faxfinder; Connecting The Faxfinder To Power, Phone Lines, And Ethernet - Multitech FaxFinder FF130 Administrator's Manual

FaxFinder 430/830 (FF830 shown)

Label Name
Power Power
Status Status
LNK Data Link
100 Speed
TD Transmit Data
RD Receive Data
CD Carrier Detect

Installing and Cabling FaxFinder

Connecting the FaxFinder to Power, Phone Lines, and
Ethernet
Note: FaxFinder 130 and 230 models come with a power supply that has interchangeable blades for
use in various countries. To change the blades:
a. Remove the protective cover by sliding down the locking switch and pulling the cover out from
the bottom (this can be discarded).
b. Select the correct blade attachment for your locale and insert the top portion of the attachment
first. There is a corresponding tab that mates with the slot in the blade attachment.
c. Hold the locking switch down and push up and in.
d. Release the locking switch to lock the attachment in.
1. Connect FaxFinder to AC Outlet.
FF130/230
a. Plug the DC power transformer into a power outlet or power strip.
b. Secure the other end to the power receptacle on the FaxFinder 130/230.
c. Secure the power cord to the connector with the lock nut. (Builds of FF130/230 for outside of
North America have a 2-piece power connection.)
FaxFinder Administrator User Guide
Solid (constant) green if unit is on.
A few moments after power is on, the Status LED will be blinking
green to show normal, working state.
Lit when a physical link has been established with the Ethernet
network.
10 MHz or 100 MHz | When lit, Ethernet rate is 100 MHz; when
not lit, Ethernet rate is 10 MHz.
The TD LED flashes when the modem is transmitting data to
another modem.
The RD LED flashes when the modem is receiving data from
another modem.
Carrier of remote modem is detected.
Chapter 2: Getting Started
Description
19