Saving System Configuration Changes; Save & Restart Button Under Menu Bar - Multitech MultiModem iSMS SF100-G Administrator's Manual

Chapter 3 – iSMS Basics and Setup Wizard

Saving System Configuration Changes

There are two types of save functions within the WEB Management menu system.
The first is a 'per feature' (per menu) save button. Most changes made per menu take effect immediately when you use
this save function. However, some changes require a system restart. These are found individually in the Sub Menu input
areas.
The second type is a system wide save function called "Save to Flash". Non-default parameters, that is, parameter
changes specific to your needs, are lost when the system restarts if you have not saved your changes to flash memory.
After you set up the MultiModem iSMS system, make sure your selections are permanently saved.
Save & Restart Button under Menu Bar
Save to Flash Memory
This is a system wide save function.
Upon system start up, system parameters are taken the unit's Flash Memory. After configuring the unit to meet your
needs, perform the "Save to Flash" function before you restart the unit.
Additionally, your changes to the Address Book, Groups, the User accounts, and Triggers (all living databases) take effect
immediately. However, the changes are lost when the system restarts if the Save to Flash is not performed before the
restart.
Save
Click Save to save your system settings to the flash memory.
Restart
This is optional. You do not have to restart the MultiModem iSMS after saving to the flash memory.
27 MultiModem® iSMS Administrator's Guide