Memory - Storage And Recall Of The Measurements; Memory-Recall Of 3 Intermittent Average Results; Memory- Cancellation Of All Measurements - Microlife Premier 3BU1-5 Instruction Manual

IB 3BU1-5(new address) 2003.8.21
5.6. Memory – storage and recall of the measurements
This blood pressure monitor automatically stores each of the last 30
measurement values per user. (Be sure to select the desired user
(either user 1 or user 2) before accessing the stored measurements.) By
pressing the MEMORY button, the last measurement (MR1) as well as
the last 29 measurements of that user (MR2, MR3,..., MR30) can be
displayed one after the other. (MR1: Values of the last measurement.)
(MR2-MR30: Values of the measurement before MR1.)
mmHg mmHg
mmHg mmHg
MR MR
MR
1
1
1
(MR1: Values of the last measurement.) (MR2: Values of the measurement before MR1.)
Further Information
When the unit is in Average Mode, time between measurements is
carefully controlled to ensure accuracy. If you take successive meas-
urements when the unit is in the single measurement mode wait for
several minutes in a relaxed position before you repeat a measure-
ment. Make sure all measurements are taken in a seated position.

5.7. Memory-recall of 3 intermittent average results

mmHg
mmHg
1
1
The blook pressure monitor can display the 3 intermittent average
results of the last stored memory. By pressing the MEMORY button at
least 3 seconds, the LCD will show A Icon first with one short beep.
16
8:42 AM Page 16
Then release the MEMORY button, and the 3 intermit-
tent average results will appear. NOTE: This only occurs
if the last stored measurement is taken in Average
Mode.
5.8.Memory– cancellation of all measurements
Attention!
To delete all stored readings, press the
MEMORY button for at least 7 seconds.
The display will show the symbol "CL"
mmHg mmHg
and 3 short beeps will sound to indicate
deletion of stored readings.
mmHg
mmHg
MR
Note:
1
If your last stored measurement was
taken in the Average Mode, you will see
A icon with a short beep during the
deletion procedure. (The display will
show these symbols during deletion of all
stored measurements if the last
measurement is taken from
Mode)
6. PRINTER FUNCTIONS
This unit can be used in connection with the Microlife diagnostic print-
er. The unit can print out measurements stored in the memory by
pressing the PRINTER button. There are 2 kinds of formats available.
mmHg mmHg
Please make sure you set the unit to User 1 or User 2 based on the
mmHg
mmHg
data you want to print.
1
1
the Average
17