User Selection - Microlife Premier 3BU1-5 Instruction Manual

IB 3BU1-5(new address) 2003.8.21
5) Press the TIME button again. The last
two characters (day) are now blinking
6) The corresponding day can now be
entered by pressing the MEMORY button.
(Example: 15 x presses)
7)Press the TIME button again. The display
now switches to the current time, during
which the first character (Hour) blinks
8) The corresponding hour can now be
entered by pressing the MEMORY button.
(Example: 9 x presses)
9) Press the TIME button again. The last
two characters (Minutes) now blink
10) The exact time can now be entered by
pressing the MEMORY button. (Example:
30 x presses)
11) Now after all settings have been made,
press the TIME button once again. The
date is briefly displayed and then the
time. The input is now confirmed and the
clock begins to run.
10
8:42 AM Page 10

4.4. User selection:

This advanced blood pressure monitor allows you to track blood pressure
readings for 2 individuals independently.
a) Before measurement make sure you set
the unit for the intended user. The unit
can track results for 2 individuals. (User 1,
User 2)
b) The unit is set to User 1. Push and hold
the Time button for 4 seconds to initiate
the user selection.
c) When the user icon is flashing, press the
MEMORY button to toggle between
users.
d) When the correct user is selected wait
three seconds for the user icon to stop
flashing. The monitor is now ready for
use.
e) Repeat the procedure again to change
users again.
Further Information
With each press of the button (TIME, MEMORY) one input is made
(e.g. switching over from hours to minutes mode, or altering the value
by +1). However, if you keep the respective button depressed, you can
switch more quickly to the desired mode, or find the desired value
respectively.
1
1
1
2
2
11