Discontinuing A Measurement; Memory - Storage And Recall Of Measurements - Microlife CVS 271249 Instruction Manual

b) After automatically reaching the correct inflation pressure,
the pump stops and the pressure slowly falls. The cuff
pressure (large characters) is displayed during the measurement.
When the device has detected the pulse, the heart symbol in the
display begins to blink and a beep tone is audible for every
pulse beat.
c) When the measurement is complete, a long
beep tone sounds. The measured systolic and
diastolic blood pressure values as well as the
pulse are displayed.
The measurement results are displayed until you switch the device off. If no
button is pressed for 5 minutes, the device switches off automatically to save
the batteries.

5.5. Discontinuing a measurement

If it is necessary to interrupt a blood pressure
measurement for any reason (e.g. the patient feels
unwell), the ON/OFF button should be pressed at any time.
The device then immediately lowers the cuff pressure auto-
matically.
5.6. Memory – storage and recall of the measurements
This blood pressure monitor automatically stores each of the
last 30 measurement values. By pressing the MEMORY
button,the last measurement ( MR 01) as well as the last 29
measurements ( MR 02, MR 03, ..., MR 30) can be displayed,
one after the other. Continue to press the memory button to
see other stored measurements.
13
Time
Systolic
Diastolic
Pulse
M