Discontinuing A Measurement - Microlife Premier 3BU1-5 Instruction Manual

IB 3BU1-5(new address) 2003.8.21
b)If you want to take a Single Mode meas-
urement position the slide switch to the
1. In this mode there is only one measure-
ment cycle.
c)Once you've selected the correct user, and
measurement mode you can press the 0/I
(ON/OFF) button to begin. After pressing
the 0/l button the pump begins to inflate
the cuff. In the display, the increasing
cuff-pressure is continually displayed.
d) After reaching the inflation pressure, the
pump stops and the pressure slowly falls.
The cuff-pressure (large characters) is dis-
played during the measurement. When
the device has detected the pulse, the
heart symbol in the display begins to
blink and a beep tone is audible for every
pulse beat.
e) When the measurement has been con-
cluded, a long beep tone sounds. The
measured systolic and diastolic blood
pressure values as well as the frequency
are now displayed. (Pulse=number of
heartbeats each minute) Example (Fig.):
Systolic 118, Diastolic 73, Pulse 75. The
measurement results are displayed, until
you switch the device off. If no button is
pressed for 5 minutes, the deviceswitches
automatically off, to save the batteries.
14
8:42 AM Page 14
f) When the unit is set to Average Mode
setting 3 separate measurements will
take place in succession followed by a
calculation of your detected blood pres-
sure value. There will be 35 seconds of
resting time in-between each measure-
ment. A count down indicates the remain-
ing time and a beep will sound 5 seconds
before the 2nd and 3rd readings begin. If
one of the measurements causes an error
message, it will be repeated one more
time. In case any additional error occurs,
the measurement will be discontinued
and an error code displayed.

5.5. Discontinuing a measurement

If it is necessary to interrupt a blood pres-
sure measurement for any reason (e.g.
1
1
the patient feels unwell), the 0/I (ON/OFF)
button can be pressed at any time. The
device then immediately lowers the
cuff-pressure automatically and enters
into sleep mode.
mmHg mmHg
mmHg mmHg
1
1
15