Usb Id Input; Installation Procedure For Program; Procedure For Program Operation - Epson EPL-6200 Service Manual

EPSON EPL-6200/EPL-6200L

5.2 USB ID Input

EPL-6200/EPL-6200L comes with the USB interface as standard, and the PC
connected to the EPL-6200/EPL-6200L via the USB interface identifies the printer by
referring to the USB ID information specific to each printer.
Since this USB ID information is stored on EEPROM on the MAIN Board of the
printer, you have to re-define the ID information by the procedure described below
when you have replaced the MAIN Board for repair.
When you repair the printer and re-define the USB ID
information, you have to tell the user to uninstall the previously
installed printer driver as it is referring to the old USB ID
information.
The program for USB ID input and the supported operating environment are as
follows:
Program
PagePrinter_Ver10E.exe
Operating environment
OS: Win95 OSR2.0 or later / Win98/WinMe/2000/XP
Port used: LPT1 ~ LPT3 (Windows95/98)
Model specific number
EPL-6200: 24
EPL-6200L: 23

5.2.1 Installation Procedure for Program

Copy the adjustment program file onto the desktop or into a folder.
The program does not run only with "PagePrinter_Ver11J.exe".
Therefore, be sure to copy also the files in the same holder.
Adjustment

5.2.2 Procedure for Program Operation

Do not start the adjustment program before connecting the
parallel cable to the printer.
This program can not be executed together with EPSON Status
Monitor on Windows 95/98. Be sure to terminate the EPSON
Status Monitor before starting the adjustment program.
If the power to the printer is turned off or the parallel cable is
disconnected during running of the adjustment program, be sure
to restart the program.
On the "Details of Display" tab of "Property of Screen", do not
change "font size."
Once you have set or input a USB ID, never forget to verify it.
1. When you execute the program, the menu window shown below will appear.
2. Select the model name and interface, and click the OK button.
Figure 5-1. Model Select Screen (Start Initial Screen)
USB ID Input
Revision A
167