Transport Area Jam In Duplex Unit (Option); Paper Re-Feed Area Jam In Duplex Unit (Option) - Epson EPL-6200 Service Manual

EPSON EPL-6200/EPL-6200L

3.3.3.3 Transport Area Jam in Duplex Unit (Option)

Detection Timing
Table 3-25. Transport Area Jam in Duplex Unit (Option)
Category
The Duplex Unit Upper Transport Sensor did not turn ON even after
Transport component
the passage of the predetermined period of time from interception of
jam
the light to the Paper Eject Sensor.
Solution: Check the "
Initial Check Items" (p.116)
following components in the order named with new ones and repeat
checking.
1. Eject Sensor (PS3)
2. Duplex Unit Upper Transport Sensor (PC4)
3.
Main Board Assy (C533/C534 Main) (p.146)
4. Duplex Unit Control Board
Before replacing any electrical part, check to see if the part in
question is defective or not by consulting
Electrical Parts"
(p.121)
Troubleshooting
Explanation
first and then replace the
(p.163)
"3.5 Troubleshooting for
. Then replace the part, if necessary.
Troubleshooting for Paper Jam

3.3.3.4 Paper Re-feed Area Jam in Duplex Unit (Option)

Detection Timing
Table 3-26. Paper Re-feed Area Jam in Duplex Unit (Option)
Category
The Paper Feed Sensor did not turn ON even after the passage of the
predetermined period of time from start of paper re-feeding.
Paper pre-feed area
jam
The Paper Feed Sensor turned ON before the passage of the
predetermined period of time from start of paper re-feeding.
The Duplex Unit Upper Transport Sensor of Duplex Unit Lower
Remaining paper
Transport Sensor was ON at turning on of the Main Switch, at
detection in paper re-
opening and closing of the Duplex Unit Cover, at occurrence of a
feed area
paper jam or at stop of paper transport.
Solution: Check the "
Initial Check Items" (p.116)
following components in the order named with new ones and repeat
checking.
1. Eject Sensor (PS3)
2. Paper Feed Sensor (S1)
3. Duplex Unit Lower Transport Sensor (PC5)
4. Duplex Unit Control Board
5.
Main Board Assy (C533/C534 Main) (p.146)
Before replacing any electrical part, check to see if the part in
question is defective or not by consulting
Electrical Parts"
(p.121)
Revision A
Explanation
first and then replace the
(p.163)
"3.5 Troubleshooting for
. Then replace the part, if necessary.
118