Jumper Setting; Notes On Installation Of Optional Units - Epson EPL-6200 Service Manual

EPSON EPL-6200/EPL-6200L

1.13.2 Jumper Setting

C533MAIN (for EPL-6200) is equipped with two resistance jumpers.
R1101
WW: Letter/A4
Installed: Letter
Not installed: A4
J: AGFA Font availability
Installed: Not available
Not installed: Available
WW spec setting Not installed (A4)
J spec setting Not installed (Font available)
C534MAIN (for EPL-6200L) is equipped with one resistance jumper.
J spec setting
WW spec setting
Product Description
Resistance Jumper
R1102
WW: No setting
J: OEM/Brand
Installed: OEM
Not installed: Brand
Not installed (default)
Not installed (brand)
Resistance Jumper
Setting for Markets
R111
Installed:
Not installed:

Notes on Installation of Optional Units

1.14 Notes on Installation of Optional Units
Notes on Installation of Duplex Unit
The Duplex Unit cannot be installed without the Lower Cassette Unit installed.
Install the Duplex Unit by the following procedure.
1. Remove the rear cover of the Lower Cassette Unit. (Two screws)
2. Install the Lower Cassette Unit on the printer body.
3. Install the Duplex Unit.
4. Remove the Connector Cover for the Duplex Unit found at the rear of the
printer body, insert the connector into the printer body, and put the Connector
Cover back in its position.
If you would like to remove the Duplex Unit, reverse the procedure of steps 1 to
•
4 above.
If you use a wrong procedure, the Duplex Unit may be broken.
Revision A
66