Long Range Wireless Access Point / Client Bridge
5.5.4 Firmware Upgrade
Click on the Upgrade Firmware link under the Management menu. This page is
used to upgrade the firmware on the device. Make sure that downloaded the
appropriate firmware from your vendor.
Click on the Browse button and then select the appropriate firmware and then
click on the Upgrade button.
Note: The upgrade process may take about 1 minute to complete. Do not power
off the device during this process as it may crash the device and make it
unusable. The device will restart automatically once the upgrade is complete.
5.5.5 Time Settings
Click on the Time Settings link under the Management menu. This page allows
you to configure the time on the device. You may do this manually or by
connecting to a NTP server.
Manually Set Date and Time: Specify the date and time
Automatically Get Date and Time: Select the time zone from the drop down list
and then specify the IP address of the NTP server.
Click on the Apply button to save the changes.
Version 1.0
40