Frame Pattern Print (Two-Sided) (Function Code 70) - Brother HL-4140CN Service Manual

1.4.16 Frame pattern print (Two-sided) (Function code 70)

<Function>
This function allows you to print one page of the frame pattern of the external circumference in
two-sided printing and check if there is any deviation or omission of print.
<Operating procedure>
(1) Load Letter-size paper on the paper tray.
(2) Press the
the maintenance mode. Then, press the OK button. "PRINTING" is displayed on the
LCD, and one page of the frame pattern (refer to the
When print is completed, "WAKU DX" is displayed on the LCD.
Note:
When printing fails, a relevant error is displayed on the LCD. Remove the cause of
error and press the Go button, and the printer automatically goes back to the
executable state, and "WAKU DX" is displayed on the LCD. Press the OK button, and
"PRINTING" is displayed on the LCD, and one page of the frame pattern is printed in
two-sided printing.
(3) Press the Cancel button to return to the printer to the initial state of the maintenance
mode.
When an error message is displayed on the LCD, take the measures described in the
table below.
Error message
TONER EMPTY # *
Cover is Open
No Paper
Jam Tray1
Jam Rear
* # indicates the toner color (K, Y, M, or C) of which cartridge became empty.
or button to display "MAINTENANCE 70" on the LCD in the initial state of
Replace the empty toner cartridge and press the Go button
to clear the error.
Close the front cover.
Replenish the letter-size paper in the tray and press the Go
button to clear the error.
Remove the jammed paper, and press the Go button to clear
the error.
5-31
next page) in two-sided printing.
Measure
Confidential