Using The Optical Image Stabilizer (Ois); Using The Face Detection - Hitachi DZ-BD10HA Instruction Manual

Notes
• It may be difficult to perform this
setting in dark places. Also if the
zoom bar is positioned in the digital
range (p.32), you may not be able to
set the white balance. If white balance
settings cannot be accomplished,
" " will continue to flash.
• If the "Set" settings are not completed
within a few moments, the camcorder
returns to recording pause mode and
" " flashes in the LCD monitor.
Redo the settings from step 1.
HDD BD-R RAM -RW (VR)
BD-RE
Using the Optical
Image Stabilizer (OIS)
OIS corrects camera movement
automatically.
Turning OIS Off/On
During recording pause, press
1
MENU.
Select "Camera Functions
2
Setup" "OIS"
Press the confirmation button
to confirm, then MENU to end.
When the function is turned On,
" " appears in the LCD
monitor (p.31).
• OIS is retained in memory
3
even when the power is turned
off.
• If "Off" is selected, be sure to
return the setting to "On"
afterwards, if you do not
normally use a tripod, etc.
50
Notes
• When OIS is active, there will be a
• Even if OIS is turned On, the camera
• OIS may not function correctly when
• We recommend turning OIS Off
-RW (VF) R CARD
HDD

Using the Face Detection

Face Detection automatically
recognizes up to five faces and shows
them in green frames.
Turning Face Detection On/Off
"On"/"Off"
1
slight divergence between the actual
camera and the on-screen movements.
movement may not be corrected if the
movement is too excessive.
We recommend you stabilize the
camcorder using both hands and
support your arms against your body
when recording.
a tele-conversion lens or wide-
conversion lens is used.
when you position the camcorder on a
table or use a tripod when recording.
CARD
BD-RE BD-R
Press .
When the function is turned On,
" " appears in the LCD
monitor (p.31).
• Face Detection is retained in
memory even when the power
is turned off.
• Recording with digital zoom
disables Face Detection even if
it is set to "On". When recording
with digital zoom (p.44), "
appears in the LCD monitor.
When you return the zoom to the
optical range, "
the LCD monitor and Face
Detection becomes active. (You
can set Face Detection to "ON"/
"OFF" while the zoom bar is
positioned in the digital range.)
"
" appears in