Hitachi DZ-BD10HA Instruction Manual page 101

Symptom
Not displayed BD, DVD-RAM, DVD-RW(VR mode), SD Card
normally in the disc recorded on this camcorder and edited on another device
navigation screen. may not be displayed normally in the disc navigation
screen. In this event, use "Update control info.".
If too much time is required to display the HDD disc
navigation screen, try the following.
1 Press
2 Select "Disc setting" or "HDD setting" or "Card
setting" by pressing e/f, then press the
confirmation button.
The "Update control info." confirmation screen
appears.
3 Select "YES" by pressing d, then press the
confirmation button.
Update of control information will begin. While
"Updating..." is being displayed, a black screen may
appear (and time may be required).
(There are some BD/DVD/Card which cannot be used
even by following the above procedures.)
The disc navigation If the inserted card contains more than 3,999 still
screen does not show pictures, only 3,999 stills can be shown in the disc
more than 3,999 navigation screen. However, it is possible to play back
stills from the more than 3,999 pictures.
inserted card.
Photos on a card This camcorder can play back image data recorded onto
cannot be played memory card using other digital cameras conforming to
back. DCF standards. However, depending on the recording
condition of the image data taken by other digital
cameras, blue thumbnails (see * of the illustration below)
appear, and playback of these images may not be
possible.
It takes some time to Stills with a large number of pixels will take more time to
play back photos. appear.
Cause and Correction
, then press MENU.
Fig. 1
Disc Navigation
All Scenes
10/ 1/2008 10:10:10 AM
PLAY SEL SELECT EXIT
0025/0030
*
Reference
page
—
—
—
—
101