Table of Contents
Advertisement
DI-206 ISDN Remote Router
56
Management
Default IP – This is the IP address that will be assigned to the dial-
in user when the IP Address Supply setting below is set to Default.
Assigning an IP address to the remote computer ensures that the IP
address does not clash with other IP addresses on your network.
IP Address Supply – This field defines how the remote user will
obtain an IP address. The choices include:
Default – Uses the Default IP address defined above,
Dynamic - Taken from the Dial In IP pool, or
None - The remote user supplies his own IP Address.
Call Back – This field determines if the router will allow call back to
the Remote Dial-In User upon dial-in. If this option is enabled, the
router will be able to call back to the Remote Dial-In User if they
request it. In such a case, the router will disconnect the initial call
from this user and dial back to the specified call back number. The
default is no call back.
Phone Number Supplied by – Toggle between Router and
Caller.
Phone Number – If Router is selected above, then this phone
number is usually provided by the person who initially set up the
router. If Caller is selected, you must enter the phone number that
will be called back yourself.
Idle Time – This is the elapsed time (in seconds) since the last valid
or active packets have gone through the router. This setting will
trigger the router to disconnect this interface when it is reached.
State – Enables or disables this User Profile.
Configuration and
Advertisement
Table of Contents
