Table of Contents
Advertisement
that will be recognized by the interface in the Local Interface
parameter.
Range – This is the range of contiguous local addresses above (and
including) the base Local IP.
State – This toggles enable/disable for this NAT entry.
Dynamic NAPT
This screen (below) is how the NAT IP Pool appears, if Dynamic
NAPT was chosen for the Translation Mode parameter. Each entry, in
this configuration, can be used to map a single global address and
multiple, contiguous local addresses to each other.
All of the parameters are the same as in Dynamic NAT, except the
Global IP is a solitary, global address.
Configuration and Management
DI-206 ISDN Remote Router
93
Advertisement
Table of Contents
