Resetting To Factory Default Settings; Backing Up And Restoring Your Settings - NETGEAR CGD24G User Manual

3. To change the password, first enter the old password, and then enter the new password twice.
4. Click Apply to save your changes.
Note: After changing the password, you will be required to log in again to continue the
configuration. If you have backed up the gateway settings previously, you should
do a new backup so that the saved settings file includes the new password.

Resetting to Factory Default Settings

You can erase the gateway configuration and reset it to the factory default settings. For information
about the factory default settings, see
gateway to its factory settings:
1. In the Set Password screen (see
Yes radio button.
2. Click Apply to save your changes.
The gateway reboots automatically. After rebooting, the gateway's password will be
password, the LAN IP address will be 192.168.0.1, and the gateway's DHCP client will be
enabled..
Note: If you do not know the login password or IP address, you can use the reset
button on the rear panel of the gateway to restore the factory default settings.
Note: When erasing and resetting the configuration, do not interrupt the process by going
on online, turning off the gateway, or shutting down the computer.

Backing Up and Restoring Your Settings

The configuration settings of the gateway are stored in a configuration file in the gateway. To see
the backup settings:
1. Log in to the gateway using its default address of http://192.168.0.1 or at whatever IP address
the unit is currently configured. Use the default user name of admin and default password of
password, or the password you have set up.
Managing Your Network
Wireless Cable Modem Gateway CGD24G User Manual
"Factory Default Settings" in Appendix A
Figure 4-3), to the right of Restore Factory Defaults, select the
v1.0, November 2008
.
To reset the
4-5