Connecting The Cgd24G Gateway - NETGEAR CGD24G User Manual

Connecting the Gateway
Note: First, install and set up the gateway using an Ethernet or USB connection to your
computer. Then configure the wireless settings. See
Configuration
Follow these steps to install your gateway:
1. Connect the gateway.
a. Turn off your computer.
b. Using the coaxial cable provided by your cable company, connect the gateway cable port
(A) to your cable line splitter or outlet.
Figure 1-5
Warning: The cable distribution system must be grounded in accordance with
c. Connect the gateway to your computer with either an Ethernet or USB cable.
Note: The USB connection option is only available for Windows PCs. Also,
For an Ethernet connection, use the Ethernet cable that shipped with your gateway to
connect a LAN port (B) to the Ethernet adapter in your computer.
Connecting the Gateway to the Internet
Wireless Cable Modem Gateway CGD24G User Manual
for instructions for wireless settings.
A
ANSI/NFPA 70 and the National Electrical Code (NEC), in particular
section 820.93, Grounding of the Outer Conductive Shield of a
Coaxial Cable.
Windows 95 does not support USB without special operating system
upgrades and patches.
v1.1, May 2009
Chapter 2, "Wireless
1-5