Router Rear Panel - NETGEAR CGD24G User Manual

Table 1-1. LED Descriptions (continued)
Downstream • On: The gateway has completed its downstream scan, and is performing upstream
Link operations, is completing configuration of the cable interface, or is fully functional with its
cable interface.
• Blink: The gateway has just powered up or it is performing a downstream scan.
• Off: The gateway's self-test and initialization is complete but it has not completed the
downstream scan.
Wireless • On: The wireless access point is operating normally.
• Blink: Data is being transmitted or received on the wireless interface.
• Blink in a fast pattern: The gateway attempts to establish a connection to a wireless
client through Wi-Fi Protected Setup (WPS).
• Off: The wireless access point is disabled.
LAN • On (green): The port has detected link with a 100 Mbps device.
(Local Area • Blink (green): Data is being transmitted or received at 100 Mbps.
Network) • On (yellow): The Local port has detected link with a 10 Mbps device.
• Blink (yellow): Data is being transmitted or received at 10 Mbps.
• Off: No link is detected on this port.

Router Rear Panel

The rear panel of the CGD24G gateway contains the connections identified below:
Figure 1-3
Connecting the Gateway to the Internet
Wireless Cable Modem Gateway CGD24G User Manual
wireless antenna
reset button
AC power adapter input
v1.1, May 2009
USB port
coaxial cable to your cable service provider
4 Ethernet LAN ports
1-3