Installing The Oven - Miele Oven Operating And Installation Instructions

Installing the oven

,
The oven must not be operated
until it has been correctly installed in
its housing unit.
In order to function correctly, the
oven requires an adequate supply
of cool air.
Ensure that the supply of cool air is
not impaired:
– do not fit a back panel in the
housing unit.
– the unit shelf on which
the oven sits must not
touch the wall behind it.
– do not fit insulation
to the side walls of the -
housing unit.
Please also ensure that the cool air
supply is not unduly heated by other
heat sources such as a wood
burning stove.
Before installation
^ Before connecting the oven to the
mains, you must disconnect the
power supply to the oven isolator
switch.
Building in
^ Connect the mains cable from the
oven to the isolator.
Lifting the oven by the door handle
can damage the door.
Use the handles at the sides of the
casing.
144
It is advisable to dismantle the door
before installing the appliance (see
"Cleaning and Care - Dismantling the
door") and remove accessories from
the oven cavity. This will make it easier
to install in its niche and you will not be
tempted into using the handle to carry
it.
^ Push the oven into the housing unit
as far as its side carrying handles.
^ Remove the side carrying handles
before pushing the oven into the
housing unit completely and aligning
it.
^ Open the door (if you have not
removed it previously).
^ Use the screws supplied to secure
the oven to the side walls of the
housing unit through the holes in the
oven trim.
^ Refit the door, if necessary (see
"Cleaning and care - Refitting the
door").