Table of Contents
Advertisement
The oven is designed to be built into
a tall unit. If you wish to install it in a
base unit, the stainless steel rail
above the control panel must be re-
placed by a sealing strip. The seal-
ing strip offers additional protection
from any liquids that might spill
down from the worktop, and can be
purchased from the Miele Spare
Parts dept.
If the oven is to be built into a base
unit, a cut-out is required in the in-
terim shelf as close as possible to
the wall or unit back panel to ensure
that there is sufficient ventilation for
the appliance.
The shape of the cut-out is not im-
portant, as long as cut-out measures
2
at least 150 cm
the cooker").
(see also "Installing
Installing the oven
Turn off the mains electricity supply
to the isolator.
^ Connect the oven to the electricity
supply by the isolator.
^ Place the oven into the oven housing
unit as far as the oven trim and align.
A fixed interim shelf must be fitted
beneath the oven.
^ Open the oven door and using two
screws secure the oven to the side
walls of the housing unit through the
holes in the oven trim.
The appliance must only be oper-
ated when it has been built in.
71
Advertisement
Table of Contents
