Mfx Tab; Mfx Ctrl Tab - Roland Integra-7 Parameter Manual

Parameter

MFX tab

MFX Switch
MFX Type
Parameters for each MFX type
MFX Chorus Send Level
MFX Reverb Send Level

MFX CTRL tab

Source (1–4)
Destination (1–4)
Sens (1–4)
Value
OFF, ON
0–67
Edit the parameters for the selected MFX type .
0–127
0–127
OFF, CC01–31, 33–95, PITCH BEND,
AFTERTOUCH, SYS CTRL1–SYS CTRL4
Sets the multi-effects parameters to be controlled with the multi-effects control . The multi-effects parameters available for control will
depend on the multi-effects type . For details, refer to
-63–+63
SuperNATURAL Acoustic Tone (SN-A) –
Explanation
Switches the multi-effect (MFX) on/off .
Use this parameter to select from among the 67 available MFXs . For details on MFX parameters,
refer to "MFX Parameters" (p . 73) .
Adjusts the amount of chorus for the sound that passes through multi-effects . If you don't want to
add the Chorus effect, set it to "0."
*
This has no effect if motional surround is on .
Adjusts the amount of reverb for the sound that passes through multi-effects . If you don't want to
"0."
add the Reverb effect, set it to
* This has no effect if motional surround is on .
Sets the MIDI message used to change the multi-effects parameter with the multi-effects control .
OFF: Multi-effects control will not be used .
CC01–31, 33–95: Control Change
PITCH BEND: Pitch Bend
AFTERTOUCH: Aftertouch
SYS CTRL1–SYS CTRL4: MIDI messages used as common multi-effects controls .
"MFX Parameters" (p . 73) .
Sets the amount of the multi-effects control's effect that is applied .
To make an increase in the currently selected value (to get higher values, move to the right,
increase rates, and so on), select a positive value; to make a decrease in the currently selected value
(to get lower values, move to the left, decrease rates, and so on), select a negative value .
For either positive or negative settings, greater absolute values will allow greater amounts of
change . Set this to "0" if you don't want to apply the effect .
MFX tab
31