How To Apply The Lfo - Roland Integra-7 Parameter Manual

PCM Synth Tone (PCMS) –
Parameter

How to Apply the LFO

Apply the LFO gradually after the key is pressed
Delay
high (more)
Time
Pitch
Cuto Frequency
Level
Pan
Note on
low (less)
Parameter Explanation
Fade Mode ON <
Delay Time The time from when the keyboard is played until the LFO begins to be applied .
Fade Time The time over which the LFO amplitude will reach the maximum after the Delay Time has elapsed .
Apply the LFO immediately when the key is pressed, and then gradually begin to decrease the effect
high (more)
Delay Time
Pitch
Cuto Frequency
Level
Pan
Note on
low (less)
Parameter Explanation
Fade Mode ON >
Delay Time
The time that the LFO will continue after the keyboard is played .
Fade Time The time over which the LFO amplitude will reach the minimum after the Delay Time has elapsed .
Apply the LFO gradually after the key is released
high (more)
Pitch
Cuto Frequency
Level
Pan
Note Note
on o
low (less)
Parameter Explanation
Fade Mode OFF <
Delay Time The time from when the keyboard is released until the LFO begins to be applied .
Fade Time The time over which the LFO amplitude will reach the maximum after the Delay Time has elapsed .
Apply the LFO from when the key is pressed until it is released, and gradually begin to decrease the effect when the key is released
high (more)
Pitch
Cuto Frequency
Level
Pan
low (less)
Note on
Parameter Explanation
Fade Mode OFF >
Delay Time The time that the LFO will continue after the keyboard is released .
Fade Time The time over which the LFO amplitude will reach the minimum after the Delay Time has elapsed .
62
How to Apply the LFO
Value
Fade Time
Depth
Fade Time
Depth
Delay
Time
Fade Time
Depth
Delay
Time Fade Time
Depth
Note o
Explanation